Pryda Australia - Specialises in timber truss and frame solutions

Pryda fabricator Sunbury Wall Frames & Trusses knew the enormous roof trusses it was manufacturing for the Bellarine Lakes Country Club Villages large community centre would be a daunting task to erect.
So managing director Danny Schneider organised to have Pryda engineers armed with Pryda Build software used to design the trusses on the Bellarine Highway, Moolap site so the site supervisor and carpenters could see a three-dimensional computerised visualisation...

Pryda has developed a new 90mm cyclonic grip in its latest battle against cyclones.
The grip is used in high wind regions for tying roof trusses to wall frames and has been added to the Pryda range to suit the increasingly popular 90mm steel frame.
The new 90mm cyclonic grip complements Pryda’s high capacity tie down product range. The product category includes tie down plates, grips and overstraps that provide uplift capacity up to 100kN. The existing cyclonic grip is 58mm wide and has been specifically...

The Pryda Shear Connector has been developed to be used in pairs to transfer the racking loads from the ceiling diaphragm to non-load bearing internal bracing walls. They can be used as a direct substitute for a pair of nail fixed timber blocks as specified...

A building height restriction presented commercial builder APM Group with real problems over where to place mechanical plant in Epping Gardens, a $30 million retirement village complex the company is building at 25 Willandra Drive, Epping – until Pryda...